The vacuum molding machine core control should be the temperature control system

Vacuum molding machine control process is very complex site optimization ranking, and action, by the hydraulic, pneumatic, vacuum, air cooling and water cooling system, heating system, servo control, proportional control, etc. But vacuum molding machine should be the core control was the temperature control system, like so much suction molding machine equipment with as much as dozens to thousands of different Numbers of the heating plate, the heating power in 100 - of the device 400 kw. Traditional vacuum molding machine control system in particular is very easy to operation, satisfied with the basic operation of equipment only necessary, but there are times when we would inevitably because of suction machines in some details of the subject, and can bring great losses to the user and the manufacturer are, so what are all these questions? As shown in the following content: 1, product qualified rate is low. If vacuum molding machine product qualified rate is low, the temperature control, power supply voltage, gas supply pressure is not stable, and environmental temperature change extremely easy to produce waste such as case, it would significantly reduce the suction molding machine work subject, and make the rejection rate of progress. 2, great power consumption. 70% of the traditional vacuum molding machine power was lost, is the great power consumption, and this kind of equipment is big as usual. 3, equipment maintenance complex poor reliability. These three topic often plagued by the user, so how to solve the above three kinds of topic is one of the important direction of vacuum molding machine development and improvement. This issue is here, the next content we currently existing in vacuum molding machine product's partial qualified rate is low, the great power consumption, equipment maintenance three complex contradiction solution is put forward.